KM-type socket with weep hole 'KMVH type'
It is a check valve that can be fixed to the formwork by passing a separator through the weep hole. Other features are the same as the KMV type.
The "KMVH type" is a product that has a socket attached to the weep hole head (water channel side). As a result, the main body of the weep hole becomes an inner pipe during the installation of the formwork, allowing it to be fixed using separators and other tools. Additionally, the head component (water channel side, rubber valve component) and the eye plate are attached after the formwork is removed. 【Features】 ■ The length of the weep hole is manufactured according to the specified dimensions based on the thickness of the concrete (approximately 100 units can be shipped the same day with AM orders). ■ The structural device is simple, reducing the risk of failure. ■ The rubber valve is supported at the center, so there is no directional requirement during installation regarding which side should face up or the angle; it can be used for both the bottom and side wall. ■ The rubber valve is made of a special synthetic rubber, providing good heat resistance, cold resistance, and weather resistance. ■ The rubber valve can be replaced. Adhesive is applied to the screw holes during installation, eliminating the risk of the rubber valve detaching. *For more details, please refer to the PDF document or feel free to contact us.
- Company：鬼頭忠兵衛商店
- Price：Other
